Back to AVTA Text-Only Home page
Using the Wheelchair Lifts
1. As the bus approaches your stop,
be sure it is the correct bus before you try to board. Each AVTA bus has a destination
sign over the windshield, and one on the curbside of the bus, displaying the
route name and number.
2. Please wait until other passengers have boarded
and position your wheelchair at least three feet back from the curb. The lift
platform will extend approximately 18 inches from the curb. Please listen and
carefully follow any instructions given by the driver.
3. Roll your chair forward onto the lift
when the driver lowers the platform. Lock your wheelchair brakes. Once your
chair is securely on the platform the driver will activate a safety barrier
to prevent your chair from rolling.
4. Once the lift has been activated
you will be raised to the level of the bus floor where you can unlock your brakes
and move off the lift.
5. Please tell the driver the location
where you want to deboard so that the driver can properly position the bus at
your departure point.
6. Your wheelchair must be properly secured
and brakes set before the driver will move the bus. A seat belt is also provided
for additional security. Please let the driver know if you need assistance in
securing your wheelchair or fastening your seat belt.
7. Please signal your departure
approximately one block ahead of your stop by using the signal cord or tape
located above the window.
8. When it is clear to do so, the driver will
raise the lift and activate the safety barrier so that you can
carefully roll your chair onto the lift, facing outward and lock your brakes.
When the lift reaches the ground, the safety barrier will lower and you will
be able to wheel away from the lift.